Sectioning on the fly can be fast and easy. You can try to use the Top, Bottom, Front, Back, Left, or Right standard sections and then move them to the desired location. At times it is also helpful and faster to use the Align to View cut, but your camera is often not straight so your cut will be at an angle. The cut I use most often is the Align to Surface cut. You may have noticed that throughout your Navisworks models there is no shortage of flat surfaces in every view. Whether it be a wall, ceiling, beam, duct, or even hanger, there are plenty of flat surfaces you can use to section quickly with the Align to Surface cut. Within two or three mouse clicks you can have a perfect section cut; when you select Align to Surface your cursor will turn into a crosshair. Use your crosshair to select a flat surface close to where you would like your final cut. Once you select your surface and your section cut is turned on with the check box next to it, you can adjust the cut with the Move command and you’re done. You can add two or more section cuts just as quickly until your scene shows what you need it to show. And if you clicked on the wrong surface or want to pick a different surface, just use the green Re-select button to the right of your cut.